Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 812
service-class bandwidth-percentage, service-class dynamic dot1p, dot1p, E-Series, Queue ID
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 812 highlights
www.dell.com | support.dell.com Version 7.6.1.0 Introduced on S-Series and on C-Series pre-Version 6.1.1.1 Introduced on E-Series Related Commands rate-shape Shape traffic output as part of the designated policy. service-class bandwidth-percentage c s Specify a minimum bandwidth for queues Syntax service-class bandwidth-percentage queue0 number queue1 number queue2 number queue3 number Parameters number Enter the bandwidth-weight, as a percentage. The value must be a power of 2. Range 1-1024. Defaults None Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.2.1.0 Introduced on S55 Introduced on C-Series and S-Series. Usage Information Guarantee a minimum bandwidth to different queues globally using the command service-class bandwidth-weight from CONFIGURATION mode. The command is applied in the same way as the bandwidth-weight command in an output QoS policy. The bandwidth-weight command in QOS-POLICY-OUT mode supersedes the service-class bandwidth-weight command. service-class dynamic dot1p c e s Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes INTERFACE mode entries. Syntax service-class dynamic dot1p To return to the default setting, enter no service-class dynamic dot1p. Defaults All dot1p traffic is mapped to Queue 0 unless service-class dynamic dot1p is enabled. Then the default mapping is as follows: Table 32-1. Default dot1p to Queue Mapping dot1p 0 1 2 E-Series Queue ID 2 0 1 C-Series Queue ID 1 0 0 S-Series Queue ID 1 0 0 812 | Quality of Service (QoS)