Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 534
management route, Configuration, Switched IP Traffic, IPV4 Only, Switched Non-IP, Traffic
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 534 highlights
www.dell.com | support.dell.com Usage Information By default, FTOS distributes incoming traffic based on a hash algorithm using the following criteria: • IP source address • IP destination address • IP Protocol type • TCP/UDP source port • TCP/UDP destination port Note: For IPV6, only the first 32 bits (LSB) of IP Source Address and IP Destination Address are used for hash generation. The table below lists the load balance command options and how the command combinations effect the distribution of traffic. Table 16-3. Configurations of the load-balance Command Configuration Default (IP 5-tuple) ip-selection 3-tuple mac ip-selection 3-tuple and mac ip-selection packet-based ip-selection packet-based and mac Switched IP Traffic IP 5-tuple IP 3-tuple MAC based MAC based Packet based: IPV4 No distribution: IPV6 MAC based Routed IP Traffic (IPV4 Only) IP 5-tuple IP 3-tuple IP 5-tuple IP 3-tuple Packet based: IPV4 Packet based: IPV4 Switched Non-IP Traffic MAC based MAC based MAC based MAC based MAC based MAC based Related Commands ip address Change the algorithm used to distribute traffic on an E-Series chassis. management route c e Configure a static route that points to the Management interface or a forwarding router. Syntax management route ip-address mask {forwarding-router-address | managementethernet} To remove a static route, use the no management route ip-address mask {forwarding-router-address | managementethernet} command. Parameters ip-address mask forwarding-router-address managementethernet Enter an IP address (dotted decimal format) and mask (/prefix format) as the IP address for the Management interface. Enter an IP address (dotted decimal format) of a forwarding router. Enter the keyword managementethernet for the Management interface on the Primary RPM. Defaults Not configured. Command Modes CONFIGURATION 534 | IPv4 Routing