Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 975
SNMP and Syslog, Overview, SNMP Commands
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 975 highlights
39 SNMP and Syslog Overview This chapter contains commands to configure and monitor SNMP v1/v2/v3 and Syslog. Both features are supported on the C-Series, E-Series, and S-Series platforms, as indicated by the following symbols under each of the command headings: c e s The chapter contains the following sections: • SNMP Commands • Syslog Commands SNMP Commands The SNMP commands available in FTOS are: • show snmp • show snmp engineID • show snmp group • show snmp user • snmp ifmib ifalias long • snmp-server community • snmp-server contact • snmp-server enable traps • snmp-server engineID • snmp-server group • snmp-server host • snmp-server location • snmp-server packetsize • snmp-server trap-source • snmp-server user • snmp-server view • snmp trap link-status The Simple Network Management Protocol (SNMP) is used to communicate management information between the network management stations and the agents in the network elements. FTOS supports SNMP versions 1, 2c, and 3, supporting both read-only and read-write modes. FTOS sends SNMP traps, which are messages informing an SNMP management system about the network. FTOS supports up to 16 SNMP trap receivers. SNMP and Syslog | 975