Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 546
load-balance mac, Parameters, Command Modes, Command, History, Usage, Information
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 546 highlights
www.dell.com | support.dell.com Parameters vrf instance interface interface source-ip address destination-ip address protocol number [tcp | udp] | icmp src-port number destination-port number E-Series Only: Show only the L3 flow as they apply to that VRF process. Enter the keyword interface followed by of the following interface keywords. • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. (OPTIONAL) Enter an in or out parameter in conjunction with the optional interface: Enter the keyword source-ip followed by the IP source address in IP address format. Enter the keyword destination-ip followed by the IP destination address in IP address format. E-Series only: Enter the keyword protocol followed by one of the protocol type keywords: tcp, udp, icmp or protocol number Enter the keyword src-port followed by the source port number. Enter the keyword destination-port followed by the destination port number. Command Modes EXEC Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.9.1.0 Version 7.6.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale Introduced VRF on the E-Series Introduced on S-Series Introduced on S-Series Introduced on C-Series Introduced for E-Series Usage Information This command provides egress port information for a given IP flow. This is useful in identifying which interface the packet will follow in the case of Port-channel and Equal Cost Multi Paths. Use this command for routed packed only. For switched packets use the show port-channel-flow command show ip flow does not compute the egress port information when load-balance mac hashing is also configured due to insufficient information (the egress MAC is not available). S-Series produces the following error message: %Error: Unable to read IP route table C-Series produces the message: %Error: FIB cannot compute the egress port with the current trunk hash setting. 546 | IPv4 Routing