Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 441

ip igmp snooping mrouter c e s Statically configure a VLAN member port as a multicast router interface. Syntax ip igmp snooping mrouter interface interface To delete a specific multicast router interface, use the no igmp snooping mrouter interface interface command. Parameters interface interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series Range: 1-128 E-Series Range: 1 to 255 for TeraScale Defaults Not configured Command Modes INTERFACE VLAN-(conf-if-vl-n) Command History Version 8.3.5.0 Introduced on the S55. Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series legacy command Usage Information FTOS provides the capability of statically configuring interface to which a multicast router is attached. To configure a static connection to the multicast router, enter the ip igmp snooping mrouter interface command in the VLAN context. The interface to the router must be a part of the VLAN where you are entering the command. Note: The S55 supports up to 95 interfaces. ip igmp snooping querier c e s Enable IGMP querier processing for the VLAN interface. Syntax ip igmp snooping querier To disable IGMP querier processing for the VLAN interface, enter no ip igmp snooping querier command. Defaults Not configured Command Modes INTERFACE VLAN-(conf-if-vl-n) Internet Group Management Protocol (IGMP) | 441