Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 638
default vlan-id, default-vlan disable, enable vlan-counters
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 638 highlights
www.dell.com | support.dell.com default vlan-id c e s Specify a VLAN as the Default VLAN. Syntax default vlan-id vlan-id To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the no default vlan-id vlan-id syntax. Parameters vlan-id Enter the VLAN ID number of the VLAN to become the new Default VLAN. Range: 1 to 4094. Default: 1 Defaults The Default VLAN is VLAN 1. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on the S55. Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information To return VLAN 1 as the Default VLAN, use this command syntax (default-vlan-id 1). The Default VLAN contains only untagged interfaces. Related Commands interface vlan Configure a VLAN. default-vlan disable c e s Disable the default VLAN so that all switchports are placed in the Null VLAN until they are explicitly configured as a member of another VLAN. Defaults The default VLAN is enabled. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.3.1.0 Introduced on the S55. Introduced Usage no default vlan disable is not listed in the running-configuration, but when the default VLAN is Information disabled, default-vlan disable is listed in the running-configuration. enable vlan-counters ex Display VLAN counters for ingress and/or egress hardware. You must be in restricted mode to use this command. Syntax enable vlan-output-counters [ingress | egress | all] 638 | Layer 2