Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 302
neighbor peer-group assigning peers, RPM0-P:RP1 %KERN-6-INT: No BGP MD5 from [peer's IP address]
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 302 highlights
www.dell.com | support.dell.com If you specify a BGP peer group by using the peer-group-name parameter, all the members of the peer group will inherit the characteristic configured with this command. If you configure a password on one neighbor, but you have not configured a password for the neighboring router, the following message appears on the console while the routers attempt to establish a BGP session between them: %RPM0-P:RP1 %KERN-6-INT: No BGP MD5 from [peer's IP address] :179 to [local router's IP address]:65524 Also, if you configure different passwords on the two routers, the following message appears on the console: %RPM0-P:RP1 %KERN-6-INT: BGP MD5 password mismatch from [peer's IP address] : 11502 to [local router's IP address] :179 Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S55. Introduced support on S-Series Introduced support on C-Series neighbor peer-group (assigning peers) c e s Enables you to assign one peer to a existing peer group. Syntax neighbor ip-address peer-group peer-group-name To delete a peer from a peer group, use the no neighbor ip-address peer-group peer-group-name command. Parameters ip-address peer-group-name Enter the IP address of the router to be included in the peer group. Enter the name of a configured peer group. Defaults Not configured. Command Modes ROUTER BGP Usage Information You can assign up to 256 peers to one peer group. When you add a peer to a peer group, it inherits all the peer group's configured parameters. A peer cannot become part of a peer group if any of the following commands are configured on the peer: • neighbor advertisement-interval • neighbor distribute-list out • neighbor filter-list out • neighbor next-hop-self • neighbor route-map out • neighbor route-reflector-client • neighbor send-community 302 | Border Gateway Protocol IPv4(BGPv4)