Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 554
Column Heading, Description, show ip route summary Command Example, Table 16-15.
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 554 highlights
www.dell.com | support.dell.com Example Figure 16-23. show ip route summary Command Example Force10>show ip route summary Route Source Active Routes Non-active Routes connected 17 0 static 3 0 ospf 100 1368 2 Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5 Total 1388 2 Total 1388 active route(s) using 222440 bytes Total 2 non-active route(s) using 128 bytes Force10> Table 16-15. show ip route summary Column Headings Column Heading Description Route Source Active Routes Non-active Routes ospf 100 Total 1388 active... Identifies how the route is configured in FTOS. Identifies the best route if a route is learned from two protocol sources. Identifies the back-up routes when a route is learned by two different protocols. If the best route or active route goes down, the non-active route will become the best route. If routing protocols (OSPF, RIP) are configured and routes are advertised, then information on those routes is displayed. Displays the number of active and non-active routes and the memory usage of those routes. If there are no routes configured in the FTOS, this line does not appear. Related Commands show ip route Display information about the routes found in switch. show ip traffic c e s View IP, ICMP, UDP, TCP and ARP traffic statistics. Syntax show ip traffic [all | cp | rp1 | rp2] Parameters Note: These options are supported only on the E-Series. all (OPTIONAL) Enter the keyword all to view statistics from all processors. If you do not enter a keyword, you also view all statistics from all processors. cp (OPTIONAL) Enter the cp to view only statistics from the Control Processor. rp1 (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route Processor 1. rp2 (OPTIONAL) Enter the keyword rp2 to view only the statistics from Route Processor 2. Command Modes EXEC Privilege Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Introduced on the S55. Introduced on E-Series ExaScale Introduced on S-Series 554 | IPv4 Routing