Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 874
neighbor, network
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 874 highlights
www.dell.com | support.dell.com Command History Usage Information Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series RIP supports a maximum of 16 ECMP paths. neighbor c e s Define a neighbor router with which to exchange RIP information. Syntax Parameters neighbor ip-address To delete a neighbor setting, use the no neighbor ip-address command. ip-address Enter the IP address, in dotted decimal format, of a router with which to exchange information. Defaults Command Modes Command History Not configured. ROUTER RIP Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers are Information possible. Related Commands Use the passive-interface command in conjunction with the neighbor command to ensure that only specific interfaces are receiving and sending data. passive-interface Sets the interface to only listen to RIP broadcasts. network c e s Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the switch. Syntax network ip-address To disable RIP for a network, use the no network ip-address command. Parameter ip-address Specify an IP network address in dotted decimal format. You cannot specify a subnet. Defaults No RIP network is configured. 874 | Router Information Protocol (RIP)