Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 637
Virtual LAN (VLAN) Commands
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 637 highlights
Virtual LAN (VLAN) Commands The following commands configure and monitor Virtual LANs (VLANs). VLANs are a virtual interface and use many of the same commands as physical interfaces. You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP, ACLs and SNMP are not supported on a VLAN. Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN interface may continually switch between Master and Backup. • description • default vlan-id • default-vlan disable • enable vlan-counters • name • show config • show vlan • tagged • track ip • untagged See also VLAN Stacking and see VLAN-related commands, such as portmode hybrid, in Chapter 15, Interfaces. description c e s Add a description about the selected VLAN. Syntax description description To remove the description from the VLAN, use the no description command. Parameters description Enter a text string description to identify the VLAN (80 characters maximum). Defaults No default behavior or values Command Modes INTERFACE VLAN Command History Version 8.3.5.0 Version 7.6.1.0 Version 6.3.1.0 Introduced on the S55. Introduced on C-Series and S-Series Introduced on E-Series Related Commands show vlan Display VLAN configuration. Layer 2 | 637