Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 172

www.dell.com | support.dell.com Usage You must save your changes before resetting the system, or all changes will be lost. Information save Save configurations created in uBoot. Syntax save Command Modes uBoot Command History Usage Information Version 8.3.5.0 Introduced on the S55. You must save your changes before resetting the system, or all changes will be lost. setenv Configure system settings. Syntax setenv [gatewayip address | primary_image f10boot location | secondary_image f10boot location | default_image f10boot location | ipaddr address | ethaddr address | enablepwdignore | stconfigignore] Parameters gatewayip address primary_image secondary_image default_image location ipaddr ethaddr address enablepwdignore stconfigignore Enter the IP address for the default gateway. Enter the keywords primary_image to configure the boot parameters used in the first attempt to boot FTOS. Enter the keywords secondary_image to configure boot parameters used if the primary operating system boot selection is not available. Enter the keywords default_image to configure boot parameters used if the secondary operating system boot parameter selection is not available. The default location should always be the internal flash device (flash:), and a verified image should be stored there. Enter the location of the image file to be loaded. The keyword f10boot must precede the location when using this command. For example, primary_image f10boot tftp://10.10.10.10/server Enter the keyword ipaddr to configure the system management IP address. Enter the keyword ethaddr to configure system management MAC address. Enter the IP address in standard IPv4 format and the MAC address in standard MAC format. Enter the keywords enableprdignore true to reload the system software without the enable password configured. Enter the keywords stconfigignore true ignore the startup configuration file when reloading the system. 172 | S55 u-Boot