Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 526

www.dell.com | support.dell.com Related Commands ip helper-address show running-config Specify the destination broadcast or host address for DHCP server requests. Display the current configuration and changes from default values. ip host c e s Assign a name and IP address to be used by the host-to-IP address mapping table. Syntax ip host name ip-address To remove an IP host, use the no ip host name [ip-address] command. Parameters name ip-address Enter a text string to associate with one IP address. Enter an IP address, in dotted decimal format, to be mapped to the name. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Introduced for E-Series ip max-frag-count c e s Set the maximum number of fragments allowed in one packet for packet re-assembly. Syntax ip max-frag-count count To place no limit on the number of fragments allowed, enter no ip max-frag-count. Parameters count Enter a number for the number of fragments allowed for re-assembly. Range: 2 to 256 Defaults No limit is set on number of fragments allowed. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S55. Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Introduced for E-Series Usage To avoid Denial of Service (DOS) attacks, keep the number of fragments allowed for re-assembly low. Information 526 | IPv4 Routing