Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 962
protocol-tunnel rate-limit, show protocol-tunnel
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 962 highlights
www.dell.com | support.dell.com Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 7.4.1.0 Introduced on S55 Introduced Usage FTOS must have the default CAM profile with the default microcode before you enable L2PT. Information protocol-tunnel rate-limit c e s Enable traffic rate limiting per box. Syntax protocol-tunnel rate-limit rate To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate command. Parameters rate Enter the rate in frames per second. Range: 75 to 3000 Default: 75 Defaults 75 Frames per second Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.4.1.0 Introduced on S55 Introduced on the C-Series, E-Series Terascale, and E-Series ExaScale. Maximum rate limit on E-Series reduced from 4000 to 3000. Introduced Example Figure 37-2. protocol-tunnel rate-limit Command Example Force10# Force10#conf Force10(conf)#protocol-tunnel rate-limit 1000 Force10(conf)# Related Commands show protocol-tunnel show running-config Display tunneling information for all VLANs Display the current configuration. show protocol-tunnel c e s Display protocol tunnel information for all or a specified VLAN-Stack VLAN. Syntax show protocol-tunnel [vlan vlan-id] Parameters vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to display information for the one VLAN. Range: 1 to 4094 962 | Service Provider Bridging