Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 589
set ipv6 next-hop, show config, Command Example
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 589 highlights
Example Figure 17-9. Command Example: route-map Force10(conf)#route-map Rmap1 Force10(config-route-map)#match ? ... ip IP specific information ipv6 IPv6 specific information ... Related Commands show config View the current configuration. set ipv6 next-hop c e Configure a filter that specifies IPv6 address as the next hop. Syntax set ipv6 next-hop ipv6-address To delete the setting, use the no set ipv6 next-hop ipv6-address command. Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format. Note: The :: notation specifies successive hexadecimal fields of zeros Defaults Not configured. Command Modes ROUTE-MAP Command History Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced support on the E-Series ExaScale Introduced support on the C-Series Introduced support on the E-Series Usage The set ipv6 next-hop command is the only way to set an IPv6 Next-Hop. Information show config c e View the current route map configuration. Syntax show config Command Modes ROUTE-MAP Command History Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced support on the E-Series ExaScale Introduced support on the C-Series Introduced support on the E-Series IPv6 Access Control Lists (IPv6 ACLs) | 589