Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 571

Version 7.8.1.0 Version 7.4.1.0 Introduced support on the C-Series Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Introduced support on the E-Series Usage Information The S-Series supports Ingress IPv6 ACLs. The S55 supports both Ingress and Egress IPv6 ACLs. The number of entries allowed per ACL is hardware-dependent. Refer to your line card documentation for detailed specification on entries allowed per ACL. Related Commands show config View the current configuration. permit c e s Select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP to configure a filter that match the filter criteria. Syntax permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command. Parameters ip-protocol-number icmp ipv6 tcp udp Enter an IPv6 protocol number. Range: 0 to 255 Enter the keyword icmp to filter Internet Control Message Protocol version 6. Enter the keyword ipv6 to filter any Internet Protocol version 6. Enter the keyword tcp to filter the Transmission Control protocol. Enter the keyword udp to filter the User Datagram Protocol. Defaults Not configured. Command Modes ACCESS-LIST Command History Version 8.3.5.0 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced support on the S55. Introduced support on the E-Series ExaScale Introduced support on the C-Series Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Introduced support on the E-Series Usage Information The S-Series supports Ingress IPv6 ACLs. The S55 supports both Ingress and Egress IPv6 ACLs. IPv6 Access Control Lists (IPv6 ACLs) | 571