Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 586

www.dell.com | support.dell.com Example The following example shows the output shown when using the test cam-usage command. Figure 17-8. Command Example: test cam-usage (C-Series) Force10#test cam-usage service-policy input LauraMapTest linecard all Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status 2 | 1 | IPv4Flow | 232 | 0 | Allowed 2 | 1 | IPv6Flow | 0 | 0 | Allowed 4 | 0 | IPv4Flow | 232 | 0 | Allowed 4 | 0 | IPv6Flow | 0 | 0 | Allowed Force10# Force10#test cam-usage service-policy input LauraMapTest linecard 4 port-set 0 Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status 4 | 0 | IPv4Flow | 232 | 0 | Allowed 4 | 0 | IPv6Flow | 0 | 0 | Allowed Force10# Force100#test cam-usage service-policy input LauraMapTest linecard 2 port-set 1 Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status 2 | 1 | IPv4Flow | 232 | 0 | Allowed 2 | 1 | IPv6Flow | 0 | 0 | Allowed Force10# Table 17-3. Output Explanations: test cam-usage Term Linecard Portpipe CAM Partition Available CAM Estimated CAM per Port Status Explanation Lists the line card or line cards that are checked. Entering all shows the status for line cards in the chassis Lists the portpipe (port-set) or port pipes (port-sets) that are checked. Entering all shows the status for line cards and port-pipes in the chassis. Shows the CAM profile of the CAM Identifies the amount of CAM space remaining for that profile Estimates the amount of CAM space the listed policy will require. Indicates whether or not the policy will be allowed in the CAM IPv6 Route Map Commands The following commands allow you to configure route maps and their redistribution criteria. • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • route-map 586 | IPv6 Access Control Lists (IPv6 ACLs)