Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 724
ip ospf transmit-delay, log-adjacency-changes, maximum-paths
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 724 highlights
www.dell.com | support.dell.com ip ospf transmit-delay c e s Set the estimated time elapsed to send a link state update packet on the interface. Syntax ip ospf transmit-delay seconds To return to the default value, enter no ip ospf transmit-delay. Parameters seconds Enter the number of seconds as the transmission time. This value should be greater than the transmission and propagation delays for the interface. Range: 1 to 3600. Default: 1 second. Defaults 1 second Command Modes INTERFACE Command History Version 8.3.5.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series log-adjacency-changes c e s Set FTOS to send a Syslog message about changes in the OSPF adjacency state. Syntax log-adjacency-changes To disable the Syslog messages, enter no log-adjacency-changes. Defaults Disabled. Command Mode ROUTER OSPF Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S55 Introduced support for Multi-Process OSPF. Introduced on S-Series Introduced on C-Series Introduced on E-Series maximum-paths c e s Enable the software to forward packets over multiple paths. Syntax maximum-paths number To disable packet forwarding over multiple paths, enter no maximum-paths. 724 | Open Shortest Path First (OSPFv2 and OSPFv3)