Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 485
Description, Table 15-8., Lines in show interfaces gigabitethernet Command Example
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 485 highlights
Table 15-8. Lines in show interfaces gigabitethernet Command Example Line AutoNegotiation Expansion 1000Base-T Control Phy Specific Control Phy Specific Status Description ParallelDetectionFault is the handshaking scheme in which the link partner continuously transmit an "idle" data packet using the Fast Ethernet MLT-3 waveform. Equipment that does not support auto-negotiation must be configured to exactly match the mode of operation as the link partner or else no link can be established. 1000Base-T requires auto-negotiation. The IEEE Ethernet standard does not support setting a speed to 1000 Mbps with the speed command without auto-negotiation. E-Series line cards support both full-duplex and half-duplex 1000BaseT. Values are: 0 - Manual MDI 1 - Manual MDIX 2 - N/A 3 - Auto MDI/MDIX Displays PHY-specific status information. Cable length represents a rough estimate in meters: 0 - < 50 meters 1 - 50 - 80 meters 2 - 80 - 110 meters 3 - 110 - 140 meters 4 - 140 meters. Link Status: Up or Down Speed: Auto 1000MB 100MB 10MB Related Commands show interfaces Display information on a specific physical interface or virtual interface. show interfaces stack-unit s Display information on all interfaces on a specific S-Series stack member. Syntax show interfaces stack-unit unit-number Parameters unit-number Enter the stack member number Unit ID range: S55: 0-11 all other S-Series: 0-7 Command Modes EXEC EXEC Privilege Interfaces | 485