Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 455
interface loopback, interface Command Example
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 455 highlights
Example Figure 15-5. interface Command Example Force10(conf)#interface gig 0/0 Force10(conf-if-gi-0/0)#exit# Usage Information Related Commands You cannot delete a physical interface. By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an interface in mode, ensure that the interface's configuration does not contain an IP address and enter the switchport command. interface loopback interface null interface port-channel interface vlan show interfaces Configure a Loopback interface. Configure a Null interface. Configure a port channel. Configure a VLAN. Display interface configuration. interface loopback c e s Configure a Loopback interface. Syntax interface loopback number To remove a loopback interface, use the no interface loopback number command. Parameters number Enter a number as the interface number. Range: 0 to 16383. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on the S55. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced Example Figure 15-6. interface loopback Command Example Force10(conf)#interface loopback 1655 Force10(conf-if-lo-1655)# Related Commands interface interface null interface port-channel interface vlan Configure a physical interface. Configure a Null interface. Configure a port channel. Configure a VLAN. Interfaces | 455