Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 869
description, distance
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 869 highlights
description c e s Enter a description of the RIP routing protocol Syntax description {description} To remove the description, use the no description {description} command. Parameters description Enter a description to identify the RIP protocol (80 characters maximum). Defaults No default behavior or values Command Modes ROUTER RIP Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-7.7.1.0 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Related Commands router rip Enter ROUTER mode on the switch. distance c e s Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower weights ("administrative distance") are preferred. Syntax distance weight [ip-address mask [prefix-name]] To return to the default values, use the no distance weight [ip-address mask] command. Parameters weight ip-address mask prefix-name Enter a number from 1 to 255 for the weight (for prioritization). The default is 120. (OPTIONAL) Enter the IP address, in dotted decimal format (A.B.C.D), of the host or network to receive the new distance metric. If you enter an IP address, you must also enter a mask for that IP address, in either dotted decimal format or /prefix format (/x) (OPTIONAL) Enter a configured prefix list name. Defaults weight = 120 Command Modes ROUTER RIP Command History Related Commands Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 default-metric Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Assign one distance metric to all routes learned using the redistribute command. Router Information Protocol (RIP) | 869