Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 523
ip domain-lookup, ip domain-name
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 523 highlights
Related Commands To view current bindings, use the show hosts command. To view DNS related configuration, use the show running-config resolve command. ip domain-name Specify a DNS server. ip domain-lookup c e s Enable dynamic host-name to address resolution (that is, DNS). Syntax ip domain-lookup To disable DNS lookup, use the no ip domain-lookup. Defaults Disabled. Command Mode CONFIGURATION Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on the S55. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Usage To fully enable DNS, also specify one or more domain name servers with the ip name-server Information command. FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out all other interfaces, including the Management port. To view current bindings, use the show hosts command. Related Commands ip name-server show hosts Specify a DNS server. View current bindings. ip domain-name c e s Configure one domain name for the switch. Syntax ip domain-name name To remove the domain name, enter no ip domain-name. Parameters name Enter one domain name to be used to complete unqualified names (that is, incomplete domain names that cannot be resolved). Defaults Command Modes Not configured. CONFIGURATION IPv4 Routing | 523