Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 283
capture bgp-pdu neighbor
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 283 highlights
Usage Information When soft-reconfiguration is enabled for a neighbor and the clear ip bgp soft in is executed, the update database stored in the router is replayed and updates are reevaluated. With this command, the replay and update process is triggered only if route-refresh request is not negotiated with the peer. If the request is indeed negotiated (upon execution of clear ip bgp soft in), then BGP sends a route-refresh request to the neighbor and receives all of the peer's updates. Note: This command is supported in BGP Router Configuration mode for IPv4 Unicast address only. Related Commands Command History clear ip bgp soft in Activate inbound policies without resetting the BGP TCP session. Version 8.3.5.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.2.1.0 Introduced on the S55. Introduced support on S-Series Introduced support on C-Series Introduced capture bgp-pdu neighbor c e s Enable capture of an IPv4 BGP neighbor packet. Syntax capture bgp-pdu neighbor ipv4-address direction {both | rx | tx} To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-pdu neighbor ipv4-address command. Parameters ipv4-address direction {both | rx | tx} Enter the IPv4 address of the target BGP neighbor. Enter the keyword direction and a direction- either rx for inbound, tx for outbound, or both. Defaults Not configured. Command Modes EXEC Privilege Related Commands capture bgp-pdu max-buffer-size show capture bgp-pdu neighbor Specify a size for the capture buffer. Display BGP packet capture information Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.5.1.0 Introduced on the S55. Introduced support on S-Series Introduced support on C-Series Introduced Border Gateway Protocol IPv4(BGPv4) | 283