Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 535
show arp
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 535 highlights
Command History Version 8.3.5.0 Version 8.3.3.1 Version 8.1.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on S55 Introduced on S60. Introduced on E-Series ExaScale Support added for C-Series Introduced for E-Series Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol route) is preferred over the Management Static route. Also, Management static routes and the Management Connected prefix are not reflected in the hardware routing tables. Related Commands interface ManagementEthernet duplex (Management) speed (Management interface) Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Set the speed for the Management interface. show arp c e s Display the ARP table. Syntax show arp [vrf vrf name][interface interface | ip ip-address [mask] | macaddress mac-address [mac-address mask]] [cpu {cp | rp1 | rp2}] [static | dynamic] [summary] Parameters vrf name cpu interface interface ip ip-address mask E-Series Only: Show only the ARP cache entries tied to the VRF process. (OPTIONAL) Enter the keyword cpu with one of the following keywords to view ARP entries on that CPU: • cp - view ARP entries on the control processer. • rp1 - view ARP entries on Routing Processor 1. • rp2 - view ARP entries on Routing Processor 2. (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For the Management interface, enter the keyword managementethernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the keyword ip followed by an IP address in the dotted decimal format. Enter the optional IP address mask in the slash prefix format (/ x). IPv4 Routing | 535