Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 682
ip multicast-limit, mac-flood-list
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 682 highlights
www.dell.com | support.dell.com Related Commands ip pim sparse-mode Enable IGMP and PIM on an interface. ip multicast-limit c e s Use this feature to limit the number of multicast entries on the system. Syntax ip multicast-limit limit Parameters limit Enter the desired maximum number of multicast entries on the system. E-Series Range: 1 to 50000 E-Series Default: 15000 C-Series Range: 1 to 10000 C-Series Default: 4000 S-Series Range: 1 to 2000 S-Series Default: 400 Defaults As above Command Modes CONFIGURATION Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 Introduced on S55 Introduced on C-Series Introduced on E-Series Usage Information This features allows the user to limit the number of multicast entries on the system. This number is the sum total of all the multicast entries on all line cards in the system. On each line card, the multicast module will only install the maximum possible number of entries, depending on the configured CAM profile. The IN-L3-McastFib CAM partition is used to store multicast routes and is a separate hardware limit that is exists per port-pipe. Any software-configured limit might be superseded by this hardware space limitation. The opposite is also true, the CAM partition might not be exhausted at the time the system-wide route limit set by the ip multicast-limit is reached. Related Commands show ip igmp groups mac-flood-list e Provide an exception to the restrict-flood configuration so that multicast frames within a specified MAC address range to be flooded on all ports in a VLAN. Syntax mac-flood-list mac-address mask vlan vlan-list [min-speed speed] Parameters mac-address mac-mask Enter a multicast MAC address in hexadecimal format. Enter the MAC Address mask. 682 | Multicast