Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 429
ip igmp access-group
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 429 highlights
Parameters group-address interface (OPTIONAL) Enter the IP multicast group address in dotted decimal format. (OPTIONAL) Enter the following keywords and slot/port or number information: Defaults Command Modes Command History Disabled EXEC Privilege Version 8.3.5.0 Introduced on the S55. Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series legacy command Usage IGMP commands accept only non-VLAN interfaces-specifying VLAN will not yield a results. This Information command displays packets for IGMP and IGMP Snooping. Note: The S55 supports up to 95 interfaces. ip igmp access-group c e s Use this feature to specify access control for packets. Syntax ip igmp access-group access-list To remove the feature, use the no ip igmp access-group access-list command. Parameters access-list Enter the name of the extended ACL (16 characters maximum). Defaults Not configured Command Modes INTERFACE (conf-if-interface-slot/port) Command History Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 Introduced on the S55. Introduced on C-Series and S-Series Introduced on E-Series Usage The access list accepted is an extended ACL. This feature is used to block IGMP reports from hosts, on Information a per-interface basis; based on the group address and source address specified in the access list. Internet Group Management Protocol (IGMP) | 429