Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 781

monitor session c e s Create a session for monitoring traffic. Syntax monitor session session-ID To delete a session, use the no monitor session session-ID command. To delete all monitor sessions, use the no monitor session command. Parameters session-ID Enter a session identification number. Range: 0 to 65535 Defaults No default values or behaviors Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.5.1.0 Version 7.4.1.0 Introduced on S55 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Figure 29-1. Command Example: monitor session Force10(conf)# monitor session 60 Force10(conf-mon-sess-60) Usage All monitor sessions contain an implicit "mode interface," that is, if no mode is designated, the mode is Information set to interface as shown in the example above. The monitor command is saved in the running configuration at the Monitor Session mode level and can be restored after a chassis reload. Related Commands show monitor session show running-config monitor session Display the monitor session Display the running configuration of a monitor session show config c e s Display the current monitor session configuration. Syntax show config Defaults No default values or behavior Command Modes MONITOR SESSION (conf-mon-sess-session-ID) Command History Version 8.3.5.0 Version 8.1.1.0 Version 7.7.1.0 Introduced on S55 Introduced on E-Series ExaScale Introduced on S-Series Port Monitoring | 781