Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 86
GigabitEthernet, port-channel, sonet, C-Series, E-Series only
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
www.dell.com | support.dell.com source tos df-bit validate-reply pattern pattern sweep-min-size sweep-max-size sweep-interval ointerface (IPv4 only) Enter the IPv4 source ip address or the source interface. • Enter the IP address in A.B.C.D format • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number: C-Series and S-Series: 1-128 E-Series: 1 to 255 for TeraScale and ExaScale • E-Series only For the SONET interfaces, enter the keyword sonet followed by slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. (IPv4 only) Enter the type of service required. Range: 0-255 Default: 0 (IPv4 only) Enter Y or N for the "don't fragment" bit in IPv4 header N: Do not set the "don't fragment" bit Y: Do set "don't fragment" bit Default is No. (IPv4 only) Enter Y or N for reply validation. N: Do not validate reply data Y: Do validate reply data Default is No. (IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF Default: 0xABCD Enter the minimum size of datagram in sweep range. Range: 52-15359 bytes Enter the maximum size of datagram in sweep range. Range: 53-15359 bytes Enter the incremental value for sweep size. 1-15308 seconds (IPv4 only) Enter the outgoing interface for multicast packets. • Enter the IP address in A.B.C.D format • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number: C-Series and S-Series: 1-128 E-Series: 1 to 255 for TeraScale and ExaScale • E-Series only For the SONET interfaces, enter the keyword sonet followed by slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. 86 | Control and Monitoring