Dell Force10 S55T FTOS Command Line Reference Guide for the S55 System FTOS 8. - Page 870
distribute-list in, distribute-list out
View all Dell Force10 S55T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 870 highlights
www.dell.com | support.dell.com distribute-list in c e s Configure a filter for incoming routing updates. Syntax Parameters distribute-list prefix-list-name in [interface] To delete the filter, use the no distribute-list prefix-list-name in command. prefix-list-name interface Enter the name of a configured prefix list. (OPTIONAL) Identifies the interface type slot/port as one of the following: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel, enter the keyword port-channel followed by a number from 1 to 32 for EtherScale, 1 to 255 for TeraScale, 1-128 on C-Series and S-Series. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults Not configured. Command Modes Command History ROUTER RIP Version 8.3.5.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S55 Introduced on S-Series Introduced on C-Series Introduced on E-Series Related Commands ip prefix-list Enter the PREFIX-LIST mode and configure a prefix list. distribute-list out c e s Configure a filter for outgoing routing updates. Syntax distribute-list prefix-list-name out [interface | bgp | connected | isis | ospf | static] To delete the filter, use the no distribute-list prefix-list-name out command. 870 | Router Information Protocol (RIP)