HP 6125G HP 6125G & 6125G/XG Blade Switches Network Management and Mon - Page 118
Configuring DLSw tests
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Step Command Remarks 5. Configure the destination port of voice probe packets. destination port port-number By default, no destination port number is configured. The destination port must be the same as that of the listening service on the NQA server. 6. Configure the codec type. codec-type { g711a | g711u Optional. | g729a } By default, the codec type is G.711 A-law. 7. Configure the advantage factor for calculating MOS advantage-factor factor and ICPIF values. Optional. By default, the advantage factor is 0. 8. Specify the source IP address of probe packets. source ip ip-address Optional. By default, no source IP address is specified. The source IP address must be the IP address of a local interface. The local interface must be up. Otherwise, no probe packets can be sent out. 9. Specify the source port number of probe packets. source port port-number Optional. By default, no source port number is specified. 10. Configure the size of the data field in each probe packet. data-size size Optional. By default, the probe packet size depends on the codec type. The default packet size is 172 bytes for G.711A-law and G.711 μ-law codec type, and 32 bytes for G.729 A-law codec type. 11. Configure the string to be filled in the data field of each probe packet. data-fill string 12. Configure the number of probe packets to be sent during each voice probe operation. 13. Configure the interval for sending probe packets during each voice probe operation. 14. Configure the interval the NQA client must wait for a response from the server before it regards the response times out. probe packet-number packet-number probe packet-interval packet-interval probe packet-timeout packet-timeout Optional. By default, the string is the hexadecimal number 00010203040506070809. Optional. 1000 by default. Optional. 20 milliseconds by default. Optional. 5000 milliseconds by default. 15. Configure optional parameters. See "Configuring optional parameters for an NQA test group" Optional. Configuring DLSw tests DLSw tests of an NQA test group are used to test the response time of a DLSw device. 111