HP 6125G HP 6125G & 6125G/XG Blade Switches Network Management and Mon - Page 33
Configuring NTP multicast mode, Network requirements
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Clock status: synchronized Clock stratum: 3 Reference clock ID: 3.0.1.31 Nominal frequency: 64.0000 Hz Actual frequency: 64.0000 Hz Clock precision: 2^7 Clock offset: 0.0000 ms Root delay: 31.00 ms Root dispersion: 8.31 ms Peer dispersion: 34.30 ms Reference time: 16:01:51.713 UTC Sep 19 2005 (C6D95F6F.B6872B02) The output shows that Switch A has synchronized to Switch C because it has a higher stratum than Switch C. # Display NTP session information for Switch A. [SwitchA-Vlan-interface2] display ntp-service sessions source reference stra reach poll now offset delay disper [1234] 3.0.1.31 127.127.1.0 2 254 64 62 -16.0 32.0 16.6 note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured Total associations : 1 The output shows that an association has been set up between Switch A and Switch C. Configuring NTP multicast mode Network requirements As shown in Figure 14, configure Device C as a reference source, with the stratum level 2. • Configure Device C to operate in multicast server mode and send multicast messages from VLAN-interface 2. • Configure Device A and Device D to operate in multicast client mode and receive multicast messages through VLAN-interface 3 and VLAN-interface 2 respectively. Figure 14 Network diagram 26