HP 6125G HP 6125G & 6125G/XG Blade Switches Network Management and Mon - Page 142
Configuration procedure, NQA collaboration configuration example, Network requirements
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
Configuration procedure Before you make the configuration, make sure the devices can reach each other. # Create a DLSw test group, and configure DLSw probe packets to use 10.2.2.2 as the destination IP address. system-view [DeviceA] nqa entry admin test [DeviceA-nqa-admin-test] type dlsw [DeviceA-nqa-admin-test-dlsw] destination ip 10.2.2.2 # Enable the saving of history records. [DeviceA-nqa-admin-test-dlsw] history-record enable [DeviceA-nqa-admin-test-dlsw] quit # Start DLSw tests. [DeviceA] nqa schedule admin test start-time now lifetime forever # Stop the DLSw tests after a period of time. [DeviceA] undo nqa schedule admin test # Display the result of the last DLSw test. [DeviceA] display nqa result admin test NQA entry (admin admin, tag test) test results: Destination IP address: 10.2.2.2 Send operation times: 1 Receive response times: 1 Min/Max/Average round trip time: 19/19/19 Square-Sum of round trip time: 361 Last succeeded probe time: 2011-01-22 10:40:27.7 Extended results: Packet loss in test: 0% Failures due to timeout: 0 Failures due to disconnect: 0 Failures due to no connection: 0 Failures due to sequence error: 0 Failures due to internal error: 0 Failures due to other errors: 0 Packet(s) arrived late: 0 # Display the history of DLSw tests. [DeviceA] display nqa history admin test NQA entry (admin admin, tag test) history record(s): Index Response Status Time 1 19 Succeeded 2011-01-22 10:40:27.7 NQA collaboration configuration example Network requirements As shown in Figure 49, configure a static route to Device C on Device A, with Device B as the next hop. Associate the static route, track entry, and NQA test group to verify whether static route is active in real time. 135