HP DL360 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide - Page 23
Disconnect the power cord and cables from the server rear panel including
UPC - 613326948835
View all HP DL360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Installing Hardware Options d. Remove the access panel. Refer to the "Removing the Access Panel" section earlier in this chapter. 3. If the server has a universal rail solution: a. Disconnect the power cord and cables from the server rear panel (including cables extending from expansion boards), moving from left to right. b. Loosen the server thumbscrews securing the cable tray to the universal rack rail and to the server (1) and remove the cable tray from the server (2). Figure 2-2: Removing the cable tray from the server 2-4 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
Installing Hardware Options
2-4
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
d.
Remove the access panel. Refer to the “Removing the Access Panel” section
earlier in this chapter.
3.
If the server has a universal rail solution:
a.
Disconnect the power cord and cables from the server rear panel (including
cables extending from expansion boards), moving from left to right.
b.
Loosen the server thumbscrews securing the cable tray to the universal rack
rail and to the server (1) and remove the cable tray from the server (2).
Figure 2-2:
Removing the cable tray from the server