HP DL360 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide - Page 30
Inserting an Expansion Board into the PCI Riser Board Assembly
UPC - 613326948835
View all HP DL360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Installing Hardware Options Inserting an Expansion Board into the PCI Riser Board Assembly To install an expansion board: CAUTION: Do not discard the expansion slot cover. If the PCI expansion board is removed in the future, the expansion slot cover must be reinstalled to maintain proper cooling. CAUTION: When installing an expansion board with a mezzanine board attached, remove the bracket between the two boards. NOTE: The PCI slots only accept 3.3 volt or universal PCI expansion boards. Expansion boards that are 5 volt cannot be used in this server. 1. Remove the expansion slot cover from the PCI riser board assembly (1). 2. Align the expansion board with the guiding groove. 3. Slide the expansion board into the slot until the board seats firmly (2). Figure 2-6: Installing an expansion board into the PCI riser board HP ProLiant DL360 Generation 3 Server Setup and Installation Guide 2-11