HP DL360 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide - Page 31
Insert the rear edge of the assembly into the PCI support slot 1.
UPC - 613326948835
View all HP DL360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Installing Hardware Options IMPORTANT: If the expansion board ships with an extender bracket, remove it from the expansion board before inserting the board into the expansion slot of the PCI riser board assembly. 4. Install the PCI riser board assembly: a. Lay the PCI riser board assembly in the chassis. b. Insert the rear edge of the assembly into the PCI support slot (1). c. Press down firmly above the expansion slot until the assembly is seated in the expansion slot (2). IMPORTANT: The server does not power up if the PCI riser board assembly is not properly seated. d. Tighten the PCI riser board thumbscrew (3). Figure 2-7: Installing the PCI riser board assembly NOTE: Procedures for installing an expansion board in PCI expansion board slot 2 are similar to the procedures documented above. 2-12 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide