HP DL360 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide - Page 57
Powering Up the Server, to Server Configuration and Utilities.
UPC - 613326948835
View all HP DL360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Server Installation 5. Route the cables to the side of the rack. 6. Route all cables for all servers in the rack. Refer to Figure 3-10 Figure 3-10: Properly routed cabling for multiple servers installed in a Compaq branded rack Powering Up the Server The server is ready to be powered up after connecting the cables to the server and installing it in the rack. To power up the server: 1. Press the Power On/Off switch. 2. Confirm a successful power-on sequence by ensuring that the Power On/Off LED is illuminated green or amber. Refer to Appendix E, "LEDs, Switches, and Jumpers." After the server has successfully powered up, begin the configuration process. Refer to Chapter 4, "Server Configuration and Utilities." If the server does not power up successfully, or if it indicates a fault, refer to Appendix D, "Troubleshooting." 3-12 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide