HP DL360 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide - Page 38
Installing a Hot-Plug Redundant Power Supply, Hot-Plug Power Supply Setup
UPC - 613326948835
View all HP DL360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Installing Hardware Options 7. Install the Processor Power Module into socket 2 (1) and close the locking latches (2). Figure 2-15: Installing a Processor Power Module NOTE: PPMs with the same part number may look different, but are functionally equivalent. Installing a Hot-Plug Redundant Power Supply NOTE: Only one PCI slot is supported when the server utilizes two hot-plug redundant power supplies. Use this section to install a hot-plug redundant power supply. Hot-Plug Power Supply Setup The server can be configured with a single hot-plug AC or DC power supply or two hot-plug AC or two hot-plug DC power supplies. When two hot-plug power supplies are installed, the server has power redundancy. Depending on the server configuration, procedures for installing or replacing the power supplies vary per the following: HP ProLiant DL360 Generation 3 Server Setup and Installation Guide 2-19