HP Dc7100 HP Compaq Business Desktop dc7100 Series Service Reference Guide, 3r - Page 100
Drives, 6.13.1 Drive Positions - compaq cmt
UPC - 829160356877
View all HP Dc7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Removal and Replacement Procedures - Convertible Minitower (CMT) Chassis 6.13 Drives The computer supports up to six drives that may be installed in various configurations. This Section describes the procedure for replacing or upgrading the storage drives. A Torx T-15 screwdriver is needed to remove and install the guide screws on a drive. Ä CAUTION: Make sure personal files on the hard drive are backed up to an external storage device before removing the hard drive. Failure to do so will result in data loss. After replacing the primary hard drive, you will need to run the Restore Plus! CD to load the Compaq factory-installed files. 6.13.1 Drive Positions Drive Positions Item Description Item Description 1 *Three 5.25-inch, half-height bays for 3 Two internal 3.5-inch, one-third height optional drive. bay for hard drives) 2 **One standard 3.5-inch, one-third height bay (1.44-MB diskette drive shown)* *The bottom 5.25-inch drive bay has a shorter depth than the upper two bays. The bottom bay supports a drive that is no more than 6.7 inches in depth, including the cables that attach to the back of the drive. Do not try to force a larger drive into the bottom bay as it could damage the drive and the system board. **Depending on the computer configuration, you may have a bezel blank in this position. If you do not have a drive in this slot, you may choose to install a 3.5-inch device (such as a diskette drive, hard drive, or Zip drive). To verify the type and size of the storage device installed in the computer, run Computer Setup. 6-20 361288-003 Service Reference Guide, dc7100