HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 134

12 EM-1016 EM-1016 Message , [EM-1016], ,, WARNING, , Cold recovery failed (). Probable Cause Indicates that a problem was discovered when performing consistency checks during a cold boot. Recommended Action Monitor the switch. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING EM-1017 Message , [EM-1017], ,, WARNING, , Uncommitted WWN change detected. Cold reboot required. Probable Cause Indicates that a user did not commit a changed world-wide name (WWN) value prior executing a reboot, power cycle, or firmwareDownload operation. Recommended Change and commit the new WWN value. Action Severity WARNING EM-1018 Message , [EM-1018], , FFDC, CRITICAL, , CP blade in slot failed to retrieve current chassis type (//0x). Probable Cause Indicates that there was a failure to read the chassis type from the system. Recommended Verify that the control processor (CP) blade is operational and is properly seated in its slot. Action Severity CRITICAL EM-1019 Message Probable Cause , [EM-1019], ,, WARNING, , Current chassis configuration option () is not compatible with standby firmware version (Pre 4.4), cannot allow HA Sync. Indicates that the current chassisConfig option is not supported by the firmware on the standby control processor (CP). This is true even if the standby comes up and appears to be operational. High availability (HA) synchronization of the CPs will not be allowed. 82 Fabric OS Message Reference 53-1000600-02