HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 489
SULB-1033, Probable Cause, Recommended, Action, Severity, Message, firmwareDownload, firmwareShow
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 489 highlights
69 SULB-1033 Probable Cause Indicates that the switch has rebooted with the new firmware and is relocating the AP firmware. Recommended Wait for the operation to complete. Action Severity WARNING SULB-1033 Message , [SULB-1033], , AUDIT, WARNING, , Switch has completed relocating the internal firmware image. Probable Cause Indicates that the firmwareDownload process has completed normally on the switch. Recommended Run the firmwareShow command to verify the firmware versions. Run the switchShow command to Action make sure the switch is enabled. Severity WARNING SULB-1034 Message , [SULB-1034], , AUDIT, ERROR, , Firmwaredownload timed out. Probable Cause The error may be caused by a switch initialization issue after the internal image is relocated. It may also be caused by an internal Ethernet issue or by persistent storage failure. Recommended Action Reboot the switch. This will cause the internal image to be relocated again. Use the firmwareDownloadStatus to monitor the progress. If the problem persists, contact your switch service provider. Severity ERROR SULB-1035 Message , [SULB-1035], , AUDIT, ERROR, , An error has occurred during relocation of the internal image. Probable Cause Indicates that an error has occurred during the relocation of the internal image. The error may be caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or persistent storage hardware failure. Recommended Reset the switch. This will cause the internal image to be relocated again. If the problem persists, Action contact your switch service provider. Severity ERROR Fabric OS Message Reference 437 53-1000600-02