HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 439

66 SEC-1101 Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configurations server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR SEC-1101 Message , [SEC-1101], ,, ERROR, , Failed to enable security on all switches. Please retry later. Probable Cause Indicates that the security enable failed on the fabric because one or more switches in the fabric are busy. Recommended Action Verify that the security event was planned. If the security event was planned, run the secFabricShow command to verify that all switches in the fabric are in the ready state. When all switches are in the ready state, retry the operation. Severity ERROR SEC-1102 Message , [SEC-1102], ,, ERROR, , Fail to download . Probable Cause Indicates that the switch failed to download certificate, security database, or policies. This can happen when switch does not get enough resources to complete the operation, fabric has not stabilized, or policy database is an invalid format. Recommended Wait for fabric to become stable and then retry the operation. If the policy database is in an illegal Action format (with configDownload), correct the format and retry the operation. Severity ERROR SEC-1104 Message , [SEC-1104], ,, ERROR, , Fail to get primary . Probable Cause Indicates that the switch failed to get either the primary certificate or a primary public key. Fabric OS Message Reference 387 53-1000600-02