HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 197

22 FCR-1073 FCR-1073 Message , [FCR-1073], ,, INFO, , Switch with domain ID in fabric has lower limit of LSAN Zones supported. Probable Cause Indicates that a switch in the backbone/edge that supports different limit of logical storage area network (LSAN) zones was detected. Recommended Action Use the fcrResourceShow command on all Fibre Channel Routers in the Meta-SAN to find the lowest supported LSAN zone limits. Please make sure that total number of LSAN zones in the Meta-SAN are within the lowest supported limit of LSAN zone Severity INFO FCR-1074 Message , [FCR-1074], ,, ERROR, , HA sync lost as remote CP supports only LSAN Zones. Probable Cause Indicates that the remote control processor (CP) has older firmware, which only supports a lower number of logical storage area network (LSAN) zones. This is causing the loss of the high-availability (HA) sync. Recommended Keep the number of LSAN Zones to the lower limit of the two CPs or upgrade the remote CP. Action Severity ERROR FCR-1075 Message , [FCR-1075], ,, ERROR, , Zone Name configuration is larger than characters in the edge fabric connected to port . Probable Cause Indicates that the zone name configuration size created in the connected fabric exceeds the maximum supported by the FC Router. This size is equal to the total number of characters used by all the zone names in the edge fabric zoning database. The limit includes both logical storage area network (LSAN) and Non-LSAN zone names defined in zoning name database of the edge fabric. Recommended Limit the zone configuration size in the edge fabric connected to this port by either reducing Action number of zones or changing the zone names to smaller names. Severity ERROR Fabric OS Message Reference 145 53-1000600-02