HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 451

66 SEC-1164 SEC-1164 Message , [SEC-1164], ,, ERROR, , Lockdown option cannot be applied on a non-FCS switch. Probable Cause Indicates that the attempt to enable security is made on a switch that is not present in the fabric configurations server (FCS) list. Recommended Add the switch into the FCS policy list when using the lockdown option to enable security. Action Severity ERROR SEC-1165 Message , [SEC-1165], ,, ERROR, , Low memory, failed to enable security on all switches. Probable Cause Indicates that the system is low on memory. Recommended Wait a few minutes and try the command again. Action Severity ERROR SEC-1166 Message , [SEC-1166], ,, ERROR, , Non FCS tries to commit failover. Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configurations server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR SEC-1167 Message Probable Cause , [SEC-1167], ,, ERROR, , Another FCS failover is in process. Command terminated. Indicates that because another failover is already in progress, this failover attempt cannot proceed. Fabric OS Message Reference 399 53-1000600-02