HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 313

30 FW-1444 Recommended No action is required. Verify that the event was planned. Action Severity INFO FW-1444 Message , [FW-1444], ,, WARNING, , state has changed to . Probable Cause Indicates that the state of the specified field-replaceable unit (FRU) has changed to "faulty". Recommended Replace the FRU. Action Severity WARNING FW-1445 Message , [FW-1445], ,, INFO, , Four power supplies are now required for 2X redundancy, Switch Status Policy values changed. Probable Cause Indicates that the switch now requires 4 power supplies and previous Switch Status Policy parameters will be overwritten to reflect this. The presence of an AP blade means that more than one power supply may be required to provide adequate power. So (even if the AP blade is powered down or removed) the Switch Status policy values will now reflect the need for 4 power supplies to maintain full (2X) redundancy. Recommended No action required, unless there are fewer than 4 power supplies active in the chassis. If there are Action fewer than 4, insert additional power supplies so that there are 4 active. Severity INFO FW-1446 Message , [FW-1446], ,, WARNING, , Four power supplies now required for 2X redundancy, not enforced by Fabric Watch due to Switch Status Policy overridden by User. Probable Cause Indicates that the switch now requires 4 power supplies for full (2X) redundancy, but the user has previously overridden the Switch Status Policy values pertaining to number of power supplies. So those values will not be automatically changed. The default values with no AP blades are: 3 out of service indicates switch status is DOWN, 0 indicates no checking for switch status MARGINAL. The default values when an AP blade is or has been present are: 2 out of service indicates switch status is DOWN, 1 out of service indicates switch status is MARGINAL Recommended Action To maintain full (2X) redundancy and proper monitoring by Fabric Watch, 4 active power supplies should be supplied and the default values associated with the presence of an AP blade should be entered with switchStatusPolicyset. Fabric OS Message Reference 261 53-1000600-02