HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 135

12 EM-1028 Recommended Either change the chassisConfig option to 1 with the chassisConfig command, or upgrade the Action firmware on the standby to the version running on the active CP. Severity WARNING EM-1028 Message , [EM-1028], , FFDC, CRITICAL, , HIL Error: failed to access history log for FRU: (rc=). Probable Cause Indicates a problem accessing the data on the world-wide name (WWN) card field-replaceable unit (FRU), or the WWN card storage area on the main logic board. The problems were encountered when the software attempted to write to the history log storage to record an event for the specified FRU. The return code is for internal use only. This is a serious hardware problem. The FRU ID value is composed of a FRU type string and an optional number to identify the unit, slot, or port. Recommended Action If the message persists, reboot or power cycle the switch. If the message still persists, replace the WWN card, or the switch (for nonbladed switches). Severity CRITICAL EM-1029 Message , [EM-1029], ,, WARNING, , , a problem occurred accessing a device on the I2C bus (). Operational status () not changed, access is being retried. Probable Cause Indicates that the I2C bus had problems and a timeout occurred. Recommended Action This is often a transient error. Watch for the EM-1048 message, which indicates that the problem has been resolved. If the error persists, check for loose or dirty connections. Remove all dust and debris prior to reseating the field-replaceable unit (FRU). If it continues to fail, replace the FRU. Severity WARNING EM-1031 Message Probable Cause , [EM-1031], ,, ERROR, , ejector not closed. Indicates that the environmental monitor (EM) has found a switch blade that is inserted, but the ejector switch is not closed. The blade in the specified slot is treated as not inserted. Fabric OS Message Reference 83 53-1000600-02