HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 151

Chapter FABR System Messages 15 FABR-1001 Message , [FABR-1001], ,, WARNING, , port , . Probable Cause Indicates that the specified switch port is isolated because of a segmentation due to mismatched configuration parameters. Recommended Action Based on the segmentation reason displayed within the message, look for a possible mismatch of relevant configuration parameters in the switches at both ends of the link. Run the configure command to modify the appropriate switch parameters on both the local and remote switch. Severity WARNING FABR-1002 Message , [FABR-1002], ,, WARNING, , fabGaid: no free multicast alias IDs. Probable Cause Indicates that the fabric does not have any available multicast alias IDs to assign to the alias server. Recommended Verify alias IDs using the fabricShow command on the principal switch. Action Severity WARNING FABR-1003 Message , [FABR-1003], ,, WARNING, , port : ILS bad size , wanted . Probable Cause Indicates that an internal link service (ILS) information unit of invalid size has been received. The neighbor switch has sent an invalid sized payload. Recommended Action Investigate the neighbor switch for problems. Run the errShow command on the neighbor switch to view the error log for additional messages. Check for a faulty cable or deteriorated small form-factor pluggable (SFP). Replace the cable or SFP if necessary. Run the portLogDumpPort command on both the receiving and transmitting ports. Fabric OS Message Reference 99 53-1000600-02