HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 89

AUTH-1025 3 Severity ERROR AUTH-1025 Message , [AUTH-1025], ,, ERROR, , Failed to get during : port . Probable Cause Indicates that the authentication process failed to get the expected information during the specified authentication phase. Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1026 Message , [AUTH-1026], ,, WARNING, , Failed to get during negotiation phase: port . Probable Cause Indicates that the authentication failed to get device or host bus adaptor (HBA) information due to an internal failure. Recommended Action Usually this problem is transient. If the authentication failed, retry the login. Reinitialize authentication using the switchDisable and switchEnable commands or the portDisable and portEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING AUTH-1027 Message , [AUTH-1027], ,, ERROR, , Failed to select during : value port . Probable Cause Indicates that the authentication process failed to select an authentication value (that is, DH Group, hash value, or protocol type) from a receiving payload for the specified authentication phase. This indicates that the local switch does not support the specified authentication value. Recommended Check the authentication configuration and reset the supported value if needed using the authUtil Action command. Fabric OS Message Reference 37 53-1000600-02