HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 139
EM-1045, Probable Cause, Recommended, Action, switchStart, Severity, Message
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
12 EM-1045 Probable Cause Indicates that the specified field-replaceable unit (FRU) cannot be powered on because the associated logical switch is shut down. Recommended Run the switchStart command on the associated logical switch. Action Severity WARNING EM-1045 Message , [EM-1045], ,, WARNING, , is being powered . Probable Cause Indicates that an automatic power adjustment is being made because of the (predicted) failure of a power supply or the insertion or removal of a port blade. If new_state is On, a port blade is being powered on because more power is available (either a power supply was inserted or a port blade was removed or powered down). If new_state is Off, a port blade has been powered down because a power supply has been faulted, because it is indicating a predicted failure. If new_state is Down (not enough power), a newly inserted port blade was not powered on because there was not enough power available. Recommended The Brocade 24000 requires only a single power supply for a fully populated chassis; however, you Action should always operate the system with at least two power supplies for redundancy. Severity WARNING EM-1046 Message , [EM-1046], ,, WARNING, , Sysctrl reports error status for blade ID for the blade in slot Probable Cause Indicates that the system controller encountered a blade with an unknown ID in the slot specified. Recommended Action If the blade ID listed is not correct, then the field-replaceable unit (FRU) header for the blade is corrupted and the blade must be replaced. For the Brocade 24000, the blade ID should be 5 for a control processor (CP) blade and 4 for a port blade. Severity WARNING EM-1047 Message Probable Cause , [EM-1047], ,, INFO, , CP in slot not faulty, CP ERROR deasserted. Indicates that the control processor (CP) is no longer faulted. This message usually follows EM-1033. The new standby CP is in the process of rebooting and has turned off the CP_ERR signal. Fabric OS Message Reference 87 53-1000600-02