HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 311

30 FW-1437 Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of marginal ports is greater than or equal to the policy set using the switchStatusPolicySet command. A port is faulty when the port value for Link Loss, Synchronization Loss, Signal Loss, Invalid word, Protocol error, cyclic redundancy check (CRC) error, Port state change or Buffer Limited Port is above the high boundary. Recommended Replace any faulty or deteriorating small form-factor pluggables (SFPs). Action Severity WARNING FW-1437 Message , [FW-1437], ,, WARNING, , Switch status change contributing factor faulty ports: . (Port(s) . Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of faulty ports is greater than or equal to the policy set by the switchStatusPolicySet command. A port is considered faulty due to hardware failure such as a faulty small form-factor pluggable (SFP) or port. Recommended Replace any faulty or deteriorating small form-factor pluggables (SFPs). Action Severity WARNING FW-1438 Message , [FW-1438], ,, WARNING, , Switch status change contributing factor Missing SFPs: missing SFPs. Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of missing small form-factor pluggables (SFPs) is greater than or equal to the policy set by the switchStatusPolicySet command. Recommended Run the switchStatusPolicySet command to modify the SFP policy or to add SFPs to the empty Action ports. Severity WARNING FW-1439 Message Probable Cause , [FW-1439], ,, WARNING, , Switch status change contributing factor Switch offline. Indicates that the switch status is not in a healthy state. This occurred because the switch is offline. Fabric OS Message Reference 259 53-1000600-02