HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 367

Chapter MFIC System Messages 48 MFIC-1001 Message , [MFIC-1001], ,, ERROR, , failure at sysmod_scn registry rc= Probable Cause Indicates that the system is temporarily out of resources. Recommended Action No action is required; this message is often transitory. If the message persists, run a switch reboot or an haFailover (if applicable). If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR MFIC-1002 Message , [MFIC-1002], ,, INFO, , Chassis FRU header not programmed for switch NID, using defaults (applies only to FICON environments). Probable Cause Indicates that custom switch node descriptor (NID) fields have not been programmed in nonvolatile storage. The default values are used. The Switch NID is used only in the following SB ELS frames: Request Node Identification Data (RNID) and Registered Link Incident Record (RLIR). The use of SB-3 link incident registration and reporting is typically limited to FICON environments. Recommended No action is required if SB-3 link incident registration and reporting is not used by the host or if Action default values are desired for the switch node descriptor fields. Severity INFO MFIC-1003 Message , [MFIC-1003], ,, WARNING, , Effective Insistent domain ID for the fabric changed from to Probable Cause Indicates that one or more switches joined the fabric with a different insistent domain ID (IDID) mode setting than the current effective IDID mode for the fabric. This message also occurs when the IDID for the fabric has been turned on or off. The possible values for state are "On" or "Off". Recommended Action IDID mode is a fabric-wide mode; make sure that any switches added to the fabric are configured with the same IDID mode as the fabric. If you are enabling or disabling IDID mode, this message is for information purposes only, and no action is required. Fabric OS Message Reference 315 53-1000600-02