HP StorageWorks 8/80 Brocade Error Message Reference Guide v6.1.0 (53-1000600- - Page 143

12 EM-1061 EM-1061 Message , [EM-1061], ,, WARNING, , Synchronization halted. Remove all blades of type or upgrade your standby CP, then reboot or run haSyncStart. Probable Cause A blade in the system is not supported by the release on the standby control processor (CP). Recommended Action Please remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken, this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the system will remain out of synchronization. Severity WARNING EM-1062 Message , [EM-1062], ,, CRITICAL, , Blade in slot faulted as it exceeds the maximum support limit of blades with Blade ID in the chassis. Probable Cause Too many blades of a particular type are in the system. Recommended Remove the faulted blade. Action Severity CRITICAL EM-1063 Message , [EM-1063], ,, CRITICAL, , Blade in slot faulted because it exceeds the maximum support limit of blades with Blade IDs in the chassis. Probable Cause Too many blades of a set of particular types are in the system. Recommended Remove the faulted blade. Action Severity CRITICAL EM-1064 Message Probable Cause , [EM-1064], ,, CRITICAL, , Blade: is being powered off (based on user configuration) upon receiving a HW ASIC ERROR, reason:. The blade is power off since a hardware (HW) application specific integrated circuit (ASIC) ERROR was detected, and the user has selected to power off the problem blade when such a condition occurred. Fabric OS Message Reference 91 53-1000600-02